Maintenance And Cleaning - Virutex PEB150 Manual De Instrucciones

6
5
1
3
15
19

10. MAINTENANCE AND CLEANING

Excess glue must be removed when necessary.
Make sure that the machine is disconnected from
electrical power supply and has cooled down com-
pletely before carrying out any of the following
maintenance tasks.
4
Surface of the edge guide (1): Remove all glue remains with a
cloth and dissolvent.
Rollers (15) and (19): Dismantle the rollers and clean them with
a cloth and dissolvent.
Guide square (3): Clean any excess glue with a cloth and dis-
solvent.
Lid (4): Remove the lid (4) and clean any glue that has accidentally
spilt from the glue tank.
Panel (5): Remove the cover (6) and clean it with a cloth and
dissolvent where necessary.
It is not necessary to clean any glue remaining in the glue tank.
When the machine is used again it will re-melt any glue that has
been left over from previous jobs.
In order to keep the machine in perfect condition and minimize
maintenance, use Virutex anti-stick silicon free CANTSPRAY.
11. NOISE AND VIBRATION LEVEL
The noise and vibration levels of this device have been measured
in accordance with European standard EN 60745-1 and serve as a
basis for comparison with other machines with similar applications.
12. WARRANTY
All VIRUTEX machines are guaranteed for 12 months from the date
of purchase, excluding any damage which is a result of incorrect
use or of natural and tear on the machine. All repairs should be
carried out by the official VIRUTEX technical assistance service.
VIRUTEX reserves the right to modify its products without prior
notice.
15