Metra 99-5722 Instrucciones De Instalación página 10

3.5mm jack steering wheel control retention:
• The 3.5mm jack is to be used to retain audio controls on the steering wheel control.
• For the radios listed below, connect the included female 3.5mm connector with
stripped leads onto the male 3.5mm SWC jack. Any remaining wires tape off and
disregard:
• Eclipse: Connect the steering wheel control wire, normally Brown, to the Brown/
White wire of the connector. Then connect the remaining steering wheel control
wire, normally Brown/White, to the Brown wire of the connector .
• Metra OE: Connect the steering wheel control Key 1 wire (Gray) to the Brown
wire.
• Kenwood or select JVC with a steering wheel control wire: Connect the Blue/
Yellow wire to the Brown wire.
Note: If your Kenwood radio auto detects as a JVC, manually set the radio type
to Kenwood. See the instructions under changing radio type.
• XITE: Connect the steering wheel control SWC-2 wire from the radio to the
Brown wire.
• Parrot Asteroid Smart or Tablet: Connect the 3.5mm jack into the AX-SWC-PARROT
(sold separately), and then connect the 4-pin connector from the AX-SWC-PARROT
into the radio.
Note: The radio must be updated to rev. 2.1.4 or higher software.
10
CONNECTIONS TO BE MADE
(CONT.)
• Universal "2 or 3 wire" radio:
as Key-A or SWC-1, to the Brown wire of the connector. Then connect the remaining
steering wheel control wire, referred to as Key-B or SWC-2, to the Brown/White wire
of the connector. If the radio comes with a third wire for ground, disregard this wire
Note: After the interface has been programmed to the vehicle, refer to the
manual provided with the radio for assigning the SWC buttons. Contact the
radio manufacturer for more information.
• For all other radios: Connect the 3.5mm jack into the port on the radio designated
for an external steering wheel control interface. Refer to the manual provided
with the radio if in doubt as to where the 3.5mm jack goes to.
4-pin harness with yellow RCA jacks:
This harness is to be used to add an aftermarket backup camera to the touchscreen display,
if so desired.
• Connect the Yellow RCA jack labeled "Rearview camera", to the RCA jack on the aftermarket
backup camera.
Note: If this method is chosen, the backup camera option must be enabled in the
Configuration Settings Screen.
• Disregard the Yellow RCA jack labeled "AUX video", it will not be used in this application.
Connect the steering wheel control wire, referred to
|
386.257.1187 MetraOnline.com
.