Connecting The Ac Power Cord - Eiki LC-XNS2600 Guia De Inicio Rapido

Adjustable foot
The projection angle can be adjusted up to
10.0 degrees with the adjustable foot.
Lift the front of the projector and press the lock
on the adjustable foot to release it.
The foot is then locked. Rotate the foot to
adjust the height and tilt angle.
Keystone distortion of projected images can be
corrected by remote control or menu operation.

Connecting the AC power cord

This projector uses nominal input voltages of
100–240V AC and it automatically applies to
different input voltages. It is designed to work
with a single-phase power system having a
grounded neutral conductor. To reduce the risk
of electrical shock, do not plug into any other
type of power system. If you are not sure of
the type of power being supplied, consult your
authorized dealer or service station. Connect
the projector with all peripheral equipment
before turning it on.
Note:
The AC outlet should be near this equipment
and must be easily accessible.
Note:
For safety, unplug the AC power cord when the projector is not in use. When the projector is
connected to an outlet with AC power cord, it is in stand-by mode and consumes a little electric
power.
Turn on the projector
1.Complete peripheral connections (with a
computer, VCR,etc.) before turning on the
projector.
2. Connect the projector's AC power cord into
AC outlet.The POWER indicator turns red.
3. Press the POWER button on top control or
on the remote control. The POWER indicator
becomes green and the cooling fans start to
work. The preparation display appears on
the screen and the countdown starts.
4. If the projector is locked with a PIN code, a
PIN code input dialog box appears. Enter
the PIN code as instructed below.
Adjustable foot
Connect the AC power cord to the projector.
Adjusting
7