Briggs & Stratton Snapper Manual Del Operador página 10

7
8
2. Portable Battery Pack: Slide the battery pack (G,
Figure 7) firmly into the battery charging bay (F). If the
red charging light does not illuminate, remove the battery
pack and reinstall. Make sure the battery pack is firmly
seated in the battery charging bay.
• Red light (A, Figure 5) indicates the battery pack is
charging normally.
• Green light (B) indicates the battery pack is fully
charged.
• Red light (C) flashes indicates that the battery pack is
either too hot or too cold and will not accept a charge.
Leave the battery pack connected and when normal
operating temperature is reached it will automatically
start charging. See the Specifications section for
normal operating temperature.
• Red/green lights (D) flashes indicate that the battery
pack will not charge and must be replaced.
3. Portable Battery Pack: From "sleep mode", the battery
will wake up in approximately ten (10) seconds.
4. Portable Battery Pack: A completely discharged battery
pack will fully charge in approximately one (1) hour. The
battery pack will stay fully charged if left on the charger.
5. Portable Battery Pack: When the green light indicates
that the battery pack is fully charged, remove the battery
pack from the charger.
10
6. Integrated Battery Pack: Connect the charger plug (G,
Figure 8) to the engine.
7. Integrated Battery Pack: A completely discharged
battery pack will fully charge in approximately four (4)
hours.
8. Integrated Battery Pack: When the green light indicates
that the battery pack is fully charged, remove from the
charger.
9. To check available charge, push the Battery Fuel Gauge
button (E, Figure 5 6).
10. When not in use, disconnect the battery charger from the
electrical outlet.
Battery Fuel Gauge
To check available charge, push the Battery Fuel Gauge
button (E, Figure 5 6). The display lights (H) will indicate the
approximate amount of available charge remaining in the
battery pack.
Display Lights
Four lights
Three lights
Two lights
One light
Light flashes
Integrated Battery Pack: When connected to the charger,
if all display lights are off then the battery is fully charged.
Disconnect the charger.
Mount Battery Pack
WARNING
Improper use of battery and charger can result in an
electrical shock or fire.
When Operating
• Keep battery charger dry. Avoid exposing battery pack to
rain or wet conditions.
• To reduce the risk of electrical shock, do not allow water
to flow into AC plug.
• Do not short circuit; never place any object into the
battery contacts.
1. Check the battery tray on top of the engine for debris
and if dirty clean with a brush or cloth. Mount the battery
pack (B, Figure 9) in the engine battery tray on top of the
engine. Make sure battery pack is securely installed.
Note: To wake up a new battery, a First Time quick charge of
approximately ten (10) seconds is required.
Available Charge
75% to 100%
50% to 75%
25% to 50%
10% to 25%
Low
www.snapper.com