Display - Akron Brass STYLE 9325 NAVIGATOR PRO Instrucciones De Instalación, Funcionamiento Y Mantenimiento

To access the Menu during normal operation, press and hold the ■ MENU button for 5 seconds . The button label will
blink with the text "MENU" while the button is being held to indicate that the Menu is being requested. When the label
stops blinking, release the button and the Menu will be displayed . Alternatively, the
both be held down at the same time for 15 seconds and this will access the Menu . NOTE: The OEM Configuration option
will only be displayed when the Menu is accessed by holding the
is used to access the menu, the OEM Configuration option will not be shown .
Throughout all of the setup and options menus, the
menu choice, or to increase or decrease a highlighted value . The three buttons below the screen will have on-screen la-
bels to identify their function . For example, pressing the ■ ENTER button will enter the highlighted menu screen . Press-
ing the = DONE button will return to the previous menu . These labels will change depending on which menu screen is
active .

7.1 Display

Menu location: Setup Menu ■ Display
The Display Menu contains options to adjust the brightness of the screen, as well as the option to display or hide the "%
open" value that overlays the valve position bar graph . The menu options are as follows:
• Auto Dim
• LCD Brightness
• Numeric Position on Graph
Auto Dim: The LCD screen can automatically dim depending on the light conditions . To enable Auto Dim,
follow these steps:
1 . Navigate to the Display Menu
2 . Use the RED or GREEN button to toggle Auto Dim on or off
3 . Press the ■ SET button to save the value .
Note: If Auto Dim is turned on, the LCD brightness option (see below) is grayed out and cannot be adjusted.
LCD Brightness: The LCD brightness can be manually set to a desired percentage if the Auto Dim option is turned off .
To adjust, follow these steps:
1 . Navigate to the display menu
2. Make sure Auto Dim is set to "OFF" (see above)
3 . Press the ■ NEXT button once so the LCD brightness value is highlighted
RED or
4 . Use the
5 . Press the ■ SET button to save the value .
Numeric Position on Graph: The % value that is displayed within the valve position bar graph can be turned on or off. To
turn on or off, follow these steps:
1 . Navigate to the display menu
2 . Press the ■ NEXT button twice so the Numeric Position on Graph value is highlighted
3 . Use the RED or
4 . Press the ■ SET button to save the value .
RED and
GREEN button to adjust the LCD brightness to the desired value
GREEN button to turn on or off
RED and GREEN buttons . If the ■ MENU button
GREEN buttons can be used to move to a different
Page 12
RED and GREEN buttons can