Valve Download - Akron Brass STYLE 9325 NAVIGATOR PRO Instrucciones De Instalación, Funcionamiento Y Mantenimiento

Valve Calibration:
When the valve is first installed, calibration must be completed to ensure accurate position sensor feedback to the sys-
tem . This is only necessary at installation or if a new motor driver, actuator or valve is installed .
****WARNING****
The valve will cycle open and closed during the calibration process . Be sure the system is not pressurized and the valve
can be cycled open and closed safely before proceeding with valve calibration .
To calibrate the valve, follow these steps:
1 . Navigate to the Valve Setup menu
2 . Use the RED or
3 . Press the ■ ENTER button to select Valve Calibration
4 . Press the ■ START button to start the calibration process .
****WARNING****
The valve will cycle open and closed several times during the calibration process after the ■ START button is pressed .
5 . When the calibration is complete, press the ■ OK button to complete the process .
Valve Options:
The Valve Options menu allows the user to change the following options:
• Motor Installed. If the Navigator Pro is to be used as a pressure and flow gauge only (no valve installed), this option
configures the controller accordingly . When the Motor Installed option is set to NO, the valve graph will not be displayed
during normal operation, and the
• CAFS Installed. If the Navigator Pro is to be used to control a CAFS solenoid, this option configures the controller ac-
cordingly . When the CAFS Installed option is set to YES, the blue button will be available on the main screen to drive a
solenoid on or off to interface with a CAFS system .
Note: The CAFS solenoid must be connected to pin 5 of the six-pin Display connector on the valve (see Section 5.1,
"ELECTRICAL INSTALLATION").
• Auto Open. When the valve is fully closed, this option allows the valve to fully open automatically with a single press of
GREEN button, instead of requiring the button to be held down until the valve is fully opened .
the
Note: If the Auto Open option is enabled, the valve will only auto-open if the valve is fully closed . Once the valve is par-
tially opened, the auto-open feature won't be available again until the valve is fully closed .
To adjust these settings, follow these steps:
1 . Navigate to the Valve Setup menu
RED or GREEN button to scroll through the list until "Valve Options" is highlighted
2 . Use the
3 . Press the ■ ENTER button to select Valve Options
4. The "Motor Installed" field will be highlighted. The default value is YES. If the controller is to be used for pressure and
flow only and a valve is not connected, use the
button to save the value . If you do not wish to change this, press the ■ NEXT button to advance to the CAFS Installed
option .
5. Now the "CAFS Installed" field will be highlighted. If a CAFS solenoid is to be driven by the system, use the RED or
GREEN button to change the value to YES . Press the ■ SET button to save the value . If you do not wish to change
this, press the ■ NEXT button to advance to the Auto Open option .
6. Now the "Auto Open" field will be highlighted. Use the RED or
to activate auto open . Press the ■ SET button to save the value . If you do not wish to change this, press the ■ DONE
button to exit the valve options menu .

7.7 Valve Download

-Refer to section 11 (Firmware updates)
GREEN button to scroll through the list until the "Valve Calibration" is highlighted
RED and GREEN buttons will not be used to control the water flow .
RED or GREEN button to change the value to NO . Press the ■ SET
GREEN button to change the value to ENABLED
Page 16