Introduction; Tools Required; Product Ratings; Overview - Akron Brass STYLE 9325 NAVIGATOR PRO Instrucciones De Instalación, Funcionamiento Y Mantenimiento

1 INTRODUCTION

The following is intended to provide the basic instructions for installation, operation and maintenance of the Akron Brass
Style 9325 Navigator Pro Valve Controller . IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY, NOTE THE
SAFE OPERATIONAL REQUIREMENTS, WARNINGS, AND CAUTIONS . USE THIS PRODUCT CORRECTLY, AND WITH
CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED . FAILURE TO DO SO MAY CAUSE DAMAGE, OR PERSONAL
INJURY, AND WILL INVALIDATE THE WARRANTY!

2 TOOLS REQUIRED

• Utility Knife
• Electricians Pliers (multipurpose, stripping and crimping)
• Appropriate electrical connectors and harnesses
• 5/32 Allen key
• 3/8 wrench

3 PRODUCT RATINGS

Model: 9325
Operating Voltage: 10 – 32VDC; 10V minimum required AT THE VALVE for proper operation .
Operating Current: 2-10A @ 12VDC, 1-5A @ 24VDC (depends on valve type)
Weight = .3 lbs [ .14 kg]
Operating Temperature: -40°C - 70°C
Storage Temperature: -40°C - 85°C
Ingress protection: IP67 equivalent
J1939 CAN networked

4 OVERVIEW

The Style 9325 Navigator Pro controller allows the user to monitor pressure and flow, and to control the valve – all from
the same interface . It is designed to be used with an Akron Brass Swing-Out valve or butterfly valve only . The Style 9325
is a display interface only and does not contain the electronics required to drive the valve open and closed . The electron-
ics that drive the valve and read the pressure and flow sensors are located on the electric actuator mounted to the valve .
The motor driver electronics are installed on all electric valves supplied with a 9325 Navigator Pro . The Navigator Pro
system communicates via J1939 CAN protocol and is a distributed system . The display is strictly a user interface that
allows the user to view information and send commands to the valve . The motor driver on the electric actuator is the unit
that interprets commands from the display and drives the valve and CAFS solenoid (if applicable). The motor driver also
reads and interprets the pressure and flow sensor information and transmits it to the display .
Page 02