Control Panel And Knobs - GE JCAS745 Manual De Uso

Care and cleaning of the range.
Pull the knobs straight off the
stem.
Wire cover holder
Clean under the range
72

Control Panel and Knobs

It is a good idea to wipe the control panel after
each use of the oven. Use a damp cloth to clean
or rinse. For cleaning, use mild soap and water or
a 50/50 solution of vinegar and water. For rins-
ing, use clean water. Polish dry with a soft cloth.
Do not use abrasive cleaners, strong liquid clean-
ers, plastic scouring pads or oven cleaners on the
control panel they will damage the finish.
The control knobs may be removed for easier
cleaning.
Oven Shelves
Clean the oven shelves with an abrasive cleanser
or scouring pad. After cleaning, rinse the shelves
with clean water and dry with a clean cloth.
NOTE: Take the shelves out of the oven before
you begin the self-clean cycle or they may dis-
color.
Oven Light Replacement (on some models)
CAUTION: Before replacing your oven light bulb, turn the oven light off
and disconnect the electrical power to the range at the main fuse or cir-
cuit breaker panel.
Be sure to let the light cover and bulb cool com-
pletely.
To remove the cover:
1. Hold a hand under the cover so it does not
fall when released. With fingers of the same
hand, firmly push back the wire cover holder.
Lift off the cover.
Do not remove any screws to remove the
cover.
2. Replace bulb with a 40-watt household appli-
ance bulb.
Storage Drawer Removal (on some models)
To remove the storage drawer:
1. Pull the drawer out all the way.
2. Tilt up the front and remove it.
Make sure the knobs are in the OFF positions and
pull them straight off the stems for cleaning.
The knobs can be cleaned in a dishwasher or
they may also be washed with soap and water.
Make sure the insides of the knobs are dry before
replacing.
Replace the knobs in the OFF position to ensure
proper placement.
To make the shelves slide more easily, apply a
small amount of vegetable oil or cooking oil to a
paper towel and wipe the edges of the oven
shelves with the paper towel.
To replace the cover:
1. Place it into groove of the light receptacle. Pull
wire forward to the center of the cover until it
snaps into place.
2. Connect electrical power to the range.
To replace the storage drawer:
1. Insert glides at the back of the drawer beyond
the stop on range glides.
2. Lift the drawer if necessary to insert easily.
3. Let the front of the drawer down, then push in
to close.