GE JCAS745 Manual De Uso página 89

Before you call for service...
Problem
Oven temperature too hot
or too cold
Clock and timer do not
work
Display goes blank
Oven door is crooked
Oven makes clicking noise
"F-and number or letter"
flash in the display
Power outage
Display flashes
Unable to get the display
to show "SF"
Possible Causes
Oven thermostat needs adjustment.
Plug on range is not completely in-
serted in the electrical outlet.
A fuse in your home may be blown or
the circuit breaker tripped.
Oven controls improperly set.
A fuse in your home may be blown or
the circuit breaker tripped.
The clock is turned off from showing in
the display.
The door is out of position.
This is the sound of the heating ele-
ment turning off and on during cook-
ing functions.
You have a function error code.
If the function code repeats:
Power outage or surge.
Power failure.
Oven control pads were not pressed
properly.
What To Do
• See the Adjust the oven thermostat-Easy to do yourself! Sec-
tion.
• Make sure electrical plug is plugged into a live, properly
grounded outlet.
• Replace fuse or reset circuit breaker.
• See the Using the clock, timer and convenience outlet section.
• Replace fuse or reset circuit breaker.
• See the Using the clock, timer and convenience outlet section.
• Because the oven door is removable, it sometimes gets out of
position during installation. To straighten the door, push down
on the high corner.
• This is normal.
• Press the OFF pad. Put the oven back into operation.
• Disconnected all power to the range for at least 30 seconds
and then reconnect power. If the function error code repeats,
call for service.
• On self-cleaning models, if a function error code appears dur-
ing the self-cleaning cycle, check the oven door latch. The latch
may have been moved, if only slightly, from the locked posi-
tion. Make sure the latch is moved to the right as far as it will
go. Press the OFF pad. Allow the oven to cool for one hour. Put
the oven back into operation.
• Some models will automatically resume their setting once the
power is restored. On models with a clock, you must reset the
clock. If the oven was in use, you must reset it by pressing the
OFF pad, setting the clock and resetting any cooking function.
• Reset the clock.
• The BAKE and BROIL pads must be pressed at the same time
and held for 3 seconds.
89