GE JCAS745 Manual De Uso página 73

Care and cleaning of the range.
Surface Unit
Drain Pan
Receptacle
Surface Units (on some models)
Be sure all the controls are turned to OFF and the
surface units are cool before attempting to re-
move them.
To clean the surface units, turn the control to the
highest setting for a minute. The coils will burn
off any soil.
To remove a surface unit:
To remove the drip pans for cleaning, the surface
units must be removed first.
Lift the surface unit about 1 inch above the drip
pan and pull it out.
Do not lift the surface unit more than 1". If you
do, it may not lie flat on the drip pan when you
plug it back in.
Repeated lifting of the surface unit more than 1
inch above the drip pan can permanently dam-
age the receptacle.
Drip Pans (if included)
Remove the surface units. Then lift out the drip
pans.
Place them in a covered container. Add ¼ cup
ammonia and let soak several hours or over-
night. Wash rinse well and dry.
The drip pans may also be cleaned in the dish-
washer.
To replace a surface unit:
Replace the drip pan into the recess in the cook-
top. Make sure the opening in the pan lines up
with the receptacle.
Insert the terminals of the surface unit through
the opening in the drip pan and into the recep-
tacle.
Guide the surface unit into place so it rests
evenly.
Do not immerse the surface units in liquids of
any kind.
Do not clean the surface units in a dishwasher.
Do not bend the surface unit plug terminals.
Do not attempt to clean, adjust or in any way
repair the plug-in receptacle.
Clean the area under the drip pans often. Built-
up soil, especially grease, may catch fire.
Do not cover the drip pans with foil. Using foil so
close to the receptacle could cause shock, fire or
damage to the range.
NOTE: Do not clean the drip pans in a self-clean-
ing oven.
73