Leaning Product And Accessories - AngelSounds JPD-100S (mini) Instrucciones

The Product will need to be returned back to us for repair. The
accessories
replacement parts shall be ordered.
6.3 Cleaning Product and Accessories
Listed below are recommendations for cleaning the Product and its
accessories.
Recommended cleaning product:
The following cleaning products may be used to clean the exterior
surfaces of the Product as well as the batteries.

Do not use abrasive cleaners or strong solvents such as acetone
or acetone-based cleaners.

Do not mix disinfecting solutions (such as bleach and ammonia) as
hazardous gases may result.

Do not clean electrical contacts or connectors with bleach.
Cleaning instructions:
1. Before cleaning the Product, turn off the device and disconnect the
power cord.
2. Before cleaning, remove all adherent soil (tissue, fluids, etc.) and
wipe thoroughly with a cloth dampened with water before applying
the cleaning solution.
3. When cleaning, do not immerse. Keep the exterior surface of the
device clean and free of dust and dirt, clean exterior surface of the
unit with a dry, soft cloth .if necessary, clean it with a soft cloth
soaked in a solution of soap and wipe dry with a clean cloth
immediately. Wipe the transducer body with soft cloth to remove
any remaining coupling gel .Clean with soap only
4. Wring any excess moisture from the cloth before cleaning.
5. Avoid pouring fluids on the device, and do not allow fluids to
penetrate the exterior surfaces of the device.
6. To prevent scratching the display, the use of a soft cloth is
recommended.
should be disposed
14
of appropriately and