Best PIK33 Instrucciones De Instalación página 11

18. INSTALL THE BLOWER (INTERIOR BLOWER) (
Install 4 no. 8 x 3/8" screws into the location as shown in the pictures below (single blower or dual blower). Do not tighten screws down
fully, leave a 1/8" gap. Hang blower unit onto blower plate (screws through the large part of the keyhole). Slide the blower to its position
(screws in the small part of the keyhole). Tighten the 4 screws.
HD0044
Single blower (P5)
Secure the blower by installing 2 more no. 8 x 3/8" screws for the P5 blower and 4 more no. 8 x 3/8" screws for P8 into the locations shown
in the pictures below (single blower or dual blower). Reinstall impeller(s) and cover.
HD0080
Single blower (P5)
FOR DUAL BLOWER UNIT, MAKE SURE THE IMPELLERS
ARE CORRECTLY INSTALLED, THE INSERT WILL NOT
WORK PROPERLY IF REVERSED.
Both impellers are different in the dual blower, one rotates
clockwise and the other counterclockwise. Each wheel and
motor have an arrow and a number on them, you have to match
them correctly (see drawing at right).
Never plug the 2-prong blower cord to the 3-prong power supply cord.
Plug the power supply to the 3-prong male connector (A) and the blower unit into the 2-prong
female receptacle (B) inside the insert.
' )
CONT D
HD0045
Dual blower (P8)
HD0081
Dual blower (P8)
1
HD0023
WARNING
!
11
FRONT
A
B
HE0022
2