6. INSTALL CUSTOM HOOD LINER (OPTIONAL)
The liners are specially designed to protect the exterior base of the custom hood. To order, refer to the table below to find the right liner
model number for your insert and width of custom hood. To view specific model information, including depths for each liner models, visit
www.BestRangeHoods.com or contact Technical support (phone number listed on page 14, in warranty text).
To install, see instruction packed with custom hood liner.
The liner must be installed before the insert.
NOTE: On some liners models, front liner piece may overlap front insert flange. If so, remove the front liner piece, assemble insert, and
reassemble front liner piece.
L
I
INER MODEL
NSERT MODEL
L3336S
L3342S
L4548S
L4554S
L4560S
7. INSTALL THE WCPI REMOTE CONTROL (OPTIONAL)
The electrical connection for the remote control is located in front of the
insert. Perform this connection before the insert installation.
For installation details, see installation instructions included with the WCPI
remote control.
8. CUT THE HOLE IN CUSTOM HOOD BASE
If it is not done yet, cut a hole in the bottom of the cabinet, using the dimensions
shown at right.
I
NSERT MODEL NUMBER
NOTES: 1. The notch shown in the inset must be cut only if the WCPI optional
remote control will be installed.
2. The recommended distance from the back to the rearmost cutout
edge is 2¼" minimum.
9. INSTALL BLOWER (INTERIOR OR EXTERIOR BLOWER)
INTERIOR BLOWER : Follow all subsequent steps of this manual.
EXTERIOR BLOWER : Refer to instructions packed with exterior blower and follow steps 13, 14, 16, 17, 19 and up of this manual.
C
USTOM HOOD NOMINAL WIDTH
PIK33
PIK33
PIK45
PIK45
PIK45
A
PIK33
32½"
PIK45
44½"
36"
42"
48"
54"
60"
HL0044
7
HA0038A
17 ¹/
"
16
2¼"
A
min.
HD0084A
3½"
16 ³/
"
8