Troubleshooting - JVC KD-SX8250 Manual De Instrucciones

What appears to be trouble is not always serious. Check the following points before calling a service
center.
Symptoms
• CD cannot be played back.
• Sound is sometimes
interrupted.
• CD-R/CD-RW cannot be
played back.
• Tracks on the CD-R/CD-RW
cannot be skipped.
• Sound cannot be heard
from the speakers.
• "NO DISC" appears on the
display .
• Disc cannot be ejected.
• This unit does not work at
all.
• SSM (Strong-station
Sequential Memory)
automatic preset does not
work.
• Static noise while listening
to the radio.
• "NO DISC" appears on the
display .
• "RESET 8" appears on the
display .
• "RESET 1" – "RESET 7"
appears on the display.

TROUBLESHOOTING

Causes
Disc is inserted upside down.
You are driving on rough
roads.
Disc is scratched.
Connections are incorrect.
CD-R/CD-RW is not finalized.
The volume level is set to the
minimum level.
Connections are incorrect.
No disc in the loading slot.
Disc is inserted incorrectly.
Disc is locked.
The built-in microcomputer
may function incorrectly due to
noise, etc.
Signals are too weak.
The antenna is not connected
firmly.
No disc in the magazine.
This unit is not connected to a
CD changer correctly.
Remedies
Insert the disc correctly.
Stop playback while driving on
rough roads.
Change the disc.
Check the cords and
connections.
• Insert a finalized
CD-R/CD-RW.
• Finalize the CD-R/CD-RW
with the component which
you used for recording.
Adjust it to the optimum level.
Check the cords and
connections.
Insert a disc into the loading slot.
Insert the disc correctly.
Unlock the disc (See page 13.)
Press the reset button on the
panel holder using a ball-point
pen after detaching the control
panel. (The clock setting and
preset stations stored in memory
are erased.) (See page 2.)
Store stations manually.
Connect the antenna firmly.
Insert a disc.
Connect this unit and the CD
changer correctly and press the
reset button of the CD changer.
Press the reset button of the CD
changer.
25