What appears to be trouble is not always serious. Check the following points before calling a service
center.
Symptoms
• Sound cannot be heard
from the speakers.
• This unit does not work
at all.
• "Panel Connect Error"
appears on the display.
• No sound comes out of
the 2nd AUDIO OUT
plug.
• SSM (Strong-station
Sequential Memory)
automatic preset does
not work.
• Static noise while
listening to the radio.
• AM band cannot be
selected.
• Disc cannot be played
back.
• CD-R/CD-RW cannot be
played back.
• Tracks on the CD-R/
CD-RW cannot be
skipped.
• Disc cannot be ejected.
• [00'00"] appears on the
display, but playback
does not start.
• Disc cannot be
recognized.
TROUBLESHOOTING
Causes
The volume level is set to the
minimum level.
Connections are incorrect.
The built-in microcomputer may
have functioned incorrectly due
to noise, etc.
The control panel is not attach
correctly and firmly.
Dual Zone is not activated
Signals are too weak.
The antenna is not connected
firmly.
Dual Zone is activated.
Disc is inserted upside down.
CD-R/CD-RW is not finalized.
Disc is locked.
You are playing a Mixed-CD.
(Playback stops at the
beginning of the first track.)
The CD player may function
incorrectly.
Remedies
Adjust it to the optimum level.
Check the cords and
connections.
Press the reset button on the
panel holder after detaching the
control panel. (The clock setting
and preset stations stored in
memory are erased.)
(See page 2.)
Remove the control panel, wipe
the connectors, then attach it
again. (See page 58.)
Activate Dual Zone.
Store stations manually.
Connect the antenna firmly.
Deactivate Dual Zone.
Insert the disc correctly.
• Insert a finalized CD-R/
CD-RW.
• Finalize the CD-R/CD-RW
with the component which
you used for recording.
Unlock the disc.
(See page 41.)
Skip to the following tracks.
Playback start with the selected
track. (For details about the
Mixed-CD, refer to "A Guide to
MP3" (separate volume).
While holding SRC, press SEL
for more than 2 seconds to eject
the disc.
69