Liberty Pumps Ascent II-ESW Manual De Instalación página 58

2) Locating the Toilet and Drilling Holes for the Fasteners
The toilet hold down fasteners should be located 16" from the wall and spaced 7" apart. This assumes
a typical baseboard of 3/4" x 5 1/2" with 3/4" quarter round. Actual baseboard dimensions must be
taken into account during installation and thus rough in dimensions may change. Refer to illustration
below.
To mount the toilet to a concrete floor, drill two holes with a masonry drill bit to the required depth.
If the floor is wood, drill two pilot holes with a standard wood drill bit.
©Copyright 2011 Liberty Pumps Inc. All rights reserved. 3