4. INSTRUCTIONS FOR THE END USER
The instructions contained in this section are for unqualified personnel.
4.1 INITIAL OPERATION
4.1.1 REMOTE CONTROL PANEL DESCRIPTION
POWER
LIGHT
CENTRAL CONTROL SYSTEM This runs the main monobloc functions.
DISPLAY
DOWN
DEFROST/UP
SET
FNC
ALARM
FAN
DEFROST
COMPRESSOR
4.1.2 STARTING THE MACHINE
Press the main switch and the leds of the display flash for a few seconds until the temperature of the cold room is displayed. A
few minutes after switching on, the compressor begins to operate.
4.1.3 TEMPERATURE SETTING
The machine operation is fully automatic in that the manufacturer has already set the "set point" temperature (cold room tempe-
rature). To change this setting, proceed as follows:
1) PRESS two times the SET button: the current setting for the "set point" temperature will then be displayed.
2) SELECT the desired temperature setting for the cold room from within the limits pre-defined by the manufacturer.
3) CHANGE the set point setting by pressing the UP button to increase the value and the DOWN button to decrease it.
Once the setting has been changed press the SET button once more.
8
6
12
fnc
set
5
4
7
Turns ON / turns OFF. This is fitted with a green pilot lamp.
Turns ON and OFF cold room light. This is fitted with an orange pilot lamp.
Display parameters values, breakdowns codes and temperature
Go through the menu voices, decreases the values
Activate defrost / go through the menu voices, increase the values
Machine status menu (short pressure), parameter programming menu ( extended pressure )
Exit function
Lighted for active alarm / blinking for tacit alarm
Lighted for evaporator fans in function
On for ongoing defrost / blinking for manual activation
Lighted for active cold / blinking for delay, protection or activation blocked
63
GB