MSA FireHawk II Instrucciones Para El Uso Y Cuidado página 6

Cinturón de rescate
Ocultar thumbs Ver también para FireHawk II:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLING THE FIREHAWK RESCUE BELT II
4. Install each of the tri-
bars from the lumbar
attachment straps into
the two center slots on
the backplate. Verify
that the tri-bars are
fully engaged by tug-
ging on the lumbar
attachment strap.
NOTE: If the ExtendAire
®
II Emergency Breathing
System is installed on the
air mask, install the hose
restraint in the right center
slot in the backplate first,
before installing the tri-bars
from the rescue belt. Install
the left tri-bar of the rescue
belt once the right side has
been securely installed with
the hose restraint in place.
NOTE: If installing the Rescue Belt II on an AirHawk II or
NFPA 1981, 2002 Edition
air mask, install the tri-bar
on the lumbar attachment
adapter in the single right
center slot of the back-
plate.
5. Install the left tri-bar into
the bottom left slot on
the backplate.
MSA 314 (L) Rev. 4 - 10115063
NOTE: If the ExtendAire II
Emergency Breathing
System is installed on the
air mask, the left tri-bar of
the rescue belt will share
the left slot on the back-
plate with the attachment
loop of the ExtendAire II
hose pouch.
6. Insert the right tri-bar of the rescue belt into the outer
right slot of the back plate.
NOTE: If the Quick-Fill hose pouch is installed on the air
mask, the right tri-bar of the rescue belt will share the right
slot on the backplate with the attachment loop of the
Quick-Fill hose pouch.
7. Attach the right and left pull straps from the rescue belt
to the adjuster buckles on the shoulder straps. Ensure
that the pull straps are not twisted.
8. If the air mask has the ExtendAire II pouch or Quick-Fill
pouch installed, the pull straps and quick-release
straps must be routed through the webbing loops on
the back of the pouch. If these pouches are not
installed, skip the following steps.
a. Disengage the snap on
the quick-release
webbing by pulling on
the end of the quick-
release strap with the
reflective patch.
b. Route the quick-release
webbing strap through
the bottom webbing loop
on the back side of the
pouch.
6

Publicidad

Tabla de contenido
loading

Tabla de contenido