Satcr Function - Promax US TV EXPLORER 2 User Manual

USER'S MANUAL. US TV EXPLORER II
When selecting the COMMANDS option in the Spectrum Analyser mode
[13] in the screen will appear a dynamic execution line in order to use with the
positioner commands: DRIVE EAST / WEST. This allows to carry out a fine adjustment
in steps or in seconds to aim the antenna through the rotary selector [1].
70
60
50
40
DRIVE EAST (STEPS)
CH:
Figure 50.- DiSEqC commands: DRIVE
Press the DiSEqC key [21] on frontal panel in order to quit the commands
execution mode and to locate the mark cursor on the frequency or channel.
5.20

SATCR function

By means of SATCR function it is possible to control the devices of a TV
installation satellite that are compatible with the SatCR
Router), which allows to concentrate manifold down frequencys (slots) by an only cable.
By this way each user using a slot can tune and decode any signal present in the
satellite.
In order to select the SATCR function, press the DiSEqC key [21] from frontal
panel, and using the rotary selector [1] activate the SATCR option. In the display are
the configuration options that users can modify: slot selection, number of slots, device
address, frequency step, pilot signal activation, and finally the frequencies
corresponding to each slot.
8
SatCR is a trademark of STMicroelectronics.
10/2007
FREQ.: 1508.80
POWER: 64.4 dB
5
12108.1 SPAN:
8
MHz
200 MHz
technology (Satellite Channel
Page 73