Safety Considerations; Description - Dustcontrol S 21000 Manual Original

Safety Considerations

Read all instructions before the machine/installation is
commissioning.
Th e equipment must be installed and maintained pro-
perly by qualifi ed personnel who have study this user
instruction. Dustcontrol does not take responsibility for
defective installation or maintenance.
Warning! When using electric machines, basic safety
precautions should always be
risk of fi re, electric shock and personal injury, including
the following:
1. Work area environment
Keep the area around the central unit clean. Do not
store or work with fl ammable liquids or gases near
the machine.
2. Overload
If there is an alarm signal it should be carefully
checked out to see that the machine is un damaged. If
there are any damaged parts these should be repaired
by a Dustcontrol authorised service centre. Always
follow the regulations pertinent to the material you
are working with. Do not use the machine for pur-
poses that it is not intended for.
3. Bodily injuries
Never let the suction come in contact with parts of
the body, for example a hand. Th e vacuum producer

Description

Th e S 21000 is a stationary dust separator for the spot
extraction of air borne pollutants and cleaning. Most of
the dust is separated in the cyclone. Th e particles are col-
lected in the bottom of the cyclone and are automati-cally
emtied when the vacuum producter is shut down. Th e
fi nest particles are separated from the air by the internal
fi lter arrangement.
4.
followed to reduce the
5.
6.
7.
8.
Th e fi ltercleaning in S 21000 is automatically done with
reverse pulse.
Th e S 21000 fi lter unit is of modular construction. Th e
inlet module can for example be both rotated and rever-
sed. Additional module rings can be installed to increase
the storage capacity of the cyclone.
S 21000 - 15
generates a high negative pressure, severe injury may
result.
Electricity
A separate lockable disconnect must be installed
where it is readily accessible to the vacuum producer.
Do not repair the electric components yourself, get
somebody qualifi ed. Faults may cause injury. See also
under section 8, 'Warnings'.
Important measure
Before working on the dust separator - always turn
off and lock the disconnect of the vacuum producer.
Maintain the machine with care
Always clean fi lter before taking of the discharge
arrangement. Always follow the regulations pertinent
to the material that you are working with. Follow
instructions.
Checking for damage
Check the machine regularly for damage. If there
are any damaged parts these should be repaired by a
Dustcontrol authorised service centre.
Warning
Use only accessories and replaceable parts which are
available in Dustcontrol catalogue. When using non-
genuine parts, especially fi lters and plastic sacks, dust
leaks could occur which may be hazardous to health.
Part No 94117