JANE KOOS Instrucciones De Uso página 18

Choosing where to install
the platform
Not all systems are the same, so we advise you
to check this in the vehicle in which the platform
is going to be installed. To install the platform,
read the instruction manual for your car, as this
will indicate which seats are compatible with the
platform. The KOOS platform is compatible with
the ISOfix categories: Classes C, D and E.
The anti-rotation leg (2) is very important for
safety, adjust it properly so that it is supported by
the floor of the vehicle. If the supporting surface
for the leg is not the actual vehicle chassis (a sto-
rage compartment for example) do not install the
platform on this seat.
18
1. Installing the platform
in the vehicle
1a - Place the platform on the vehicle seat with the anti-
rotation leg (2) and the KOOS fastening guard (10)
unfolded.
1b -
Take the ISOfix fasteners out (3) turning the button (5)
on the front of the base.
1c -
Guide both fasteners (3) towards the ISOfix axles of
your vehicle and press until both sides are locked into
place. Two green signals will appear on the release
buttons (4) indicating that they are correctly fastened.
If one or both indicators are red, try it again.
1d -
Adjust the height of the leg (2) so that it is supported
by the floor of the vehicle, the indicator on the base of
the leg (11) will turn green.
Removing the platform
1e -
Loosen the platform by turning the handle on the front
of the platform (5).
1f -
Release the ISOfix fasteners by pulling the buttons (4),
the button indicator will turn red.
1g -
Remove the platform.