Optika Italy SZ Serie Manual De Instrucciones página 24

5. Head holder can be installed in several ways
according to specific need of the user.
Installation mode n° 1: (Fig. 25-27)
Insert the rear part of the head support (round black
part) ③ (Fig. 25) from the top into the hole of the
horizontal arm ④ and screw in the prevention knob
② from the bottom.
• This mode allows the installation of heavy
heads (or with heavy cameras installed on top
of the head).
Installation mode n° 2:
Insert the rear part of the head support (round black
part) ③ (Fig. 28) from below into the hole in the
horizontal arm and screw in the prevention knob ②
from above.
④
Page 24
②
③
F ig. 25 F ig. 25
F ig. 26 F ig. 26
F F ig. 27 ig. 27
F ig. 28 F ig. 28