Sz-St7 / Sz-St8; Sz-Stl1 - Optika Italy SZ Serie Manual De Instrucciones

3. Connect the power supply plug to the socket on
the back of the microscope base. (Fig. 4)

7.11.4 SZ-ST7 / SZ-ST8

1. Remove the base from its packaging and place it
on a flat surface. The base is already assembled
from the factory and does not require any further
assembly procedure other than that of mounting
the focusing system.
2. Connect the power supply plug to the socket on
the back of the microscope base. (Fig. 4)

7.11.5 SZ-STL1

1. Screw the pillar on the base. (Fig. 5)
2. Tighten the screw to lock the pillar. (Fig. 6)
Page 18
F ig. 4 F ig. 4
F F ig. 5 ig. 5
F ig. 6 F ig. 6