Hilti WSC 85 Manual De Instrucciones página 19

Noise information
Typical A-weighted sound power level
Typical A-weighted emission sound pressure level
Uncertainty
Information about vibration
Tri-axial vibration value (vibration vector sum) for sawing
wood (a )
h
Uncertainty (K)
4.3 Information for users as per EN 61000-3-11
Switching on causes a brief drop in voltage. Other appliances may be negatively affected on mains supplies
where conditions are unfavorable. No malfunctions are to be expected on mains supplies with an impedance
of <0.15 ohms.
5 Operation
5.1 Removing the saw blade
WARNING
Risk of burning injury. A hot accessory tool, clamping flange or clamping screw and the sharp edges
of the saw blade present hazards.
▶ Wear protective gloves when changing saw blades.
1. Rest the power tool on the ribbing.
2. Lock the spindle by holding the drive-spindle lock button down with one hand.
3. Use an Allen key to slacken the flange screw underneath the motor cover.
4. Use the adjusting lever to set the cutting depth to 0.
5. Use the Allen key to turn the screw counter-clockwise to remove.
6. Remove the clamping flange.
7. Open the pivoting guard.
8. Hold the pivoting guard so that it does not move.
9. Remove the saw blade.
5.2 Fitting the saw blade
CAUTION
Risk of damage Unsuitable or incorrectly fitted saw blades may damage the saw.
▶ Only use blades which are suitable for this saw. Observe the direction-of-rotation arrow on the
saw blade.
1. Rest the power tool on the ribs provided.
2. Lock the arbor by holding the arbor lockbutton down with one hand.
3. Fit the clamping flange onto the arbor.
4. Tighten the bolt securely.
5. Make sure that the clamping flange is seated correctly.
Note
The riving knife thickness must be less than the kerf width of the saw blade and at least equal to
the saw blade disc thickness.
Gap A must be less than 6 mm (0.2 in).
Printed: 19.08.2016 | Doc-Nr: PUB / 5071332 / 000 / 03
2
3
WSC 85
111 dB(A)
100 dB(A)
3 dB(A)
WSC 85
≈ 2.5 m/s²
(≈ 8.2 ft/s²)
1.5 m/s²
(4.9 ft/s²)
English 15