Care And Maintenance; Checks After Cleaning And Maintenance; Cleaning The Guard; Manufacturer's Warranty - Hilti WSC 85 Manual De Instrucciones

6. Set the cutting depth. → page 16
7. Make the cut.
8. Switch the power tool off. → page 16
9. Wait until the saw blade has stopped rotating.
10. Lift the saw clear.

6 Care and maintenance

6.1 Checks after cleaning and maintenance

Note
After cleaning or maintenance, check that all safety devices are fitted and that they function faultlessly.
▶ To check the pivoting guard, open the guard fully by moving the guard operating lever.
◁ The pivoting guard must close quickly and completely when the guard operating lever is released.

6.2 Cleaning the guard

1. Remove the saw blade. → page 15
2. Clean the parts of the guard carefully with a dry brush.
3. Use a suitable tool to remove deposits or cuttings from the inside surfaces of the parts of the guard.
4. Fit the saw blade. → page 15
7 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Disposal of electric tools or appliances together with household waste is not permissible.

8 Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Printed: 19.08.2016 | Doc-Nr: PUB / 5071332 / 000 / 03
English 17