Sauder 420567 Manual Del Usaurio página 9

Step 5 Step
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into
å
the ENDS (A and B) until the shoulders of the SCREWS
rest on the surfaces of the ENDS.
NOTE: Do not overtighten the SCREWS.
å
Slide the END MOLDINGS (P) onto the ENDS (A and B).
å
Line up the grooves in the MOLDINGS over the heads of
the SCREWS in the ENDS.
NOTE: If the MOLDING comes up off of the SCREWS,
å
remove it and slide it on again.
These edges
should be even.
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
www.sauder.com/service
P
Shoulder
P
These edges
should be even.
BLACK 9/16" FLAT HEAD SCREW
B
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
32S
A
420567
32S
(4 used in this step)
Shoulder
Page 9