Wall Or Counter Mounted Cheesemelters; Model Gircm36C - Garland G Serie Manual De Instalación Y Operación

INSTALLATION Continued
2 . Install the left and right support brackets (part # 4523226
and 4523227) using the 2 screws removed in step 1
(detail I) and one additional screw on both sides of the
range, and center support bracket (part # 4523282) with
the four screws removed in step 1 (detail II) .
INSERTED
SCREWS
4 INSERTED
SCREWS
WITH STANDARD OVEN
4 INSERTED
SCREWS
WITH CONVECTION OVEN
3 . Slide the cheesemelter down into the support brackets
installed in step 2, see figure 3 .
Part # 4526027 (01/07/09)
DETAIL I
ALL 60" MODELS
DETAIL II
FOR 60" RANGES
DETAIL II
FOR 60" RANGES
4 . Once the cheesemelter is in place, fasten it to the unit on
both sides of the range with the provided #14B x 5/8 hex
washer head tapping screws (detail I) and the center to the
support bracket using 4 of the provided screws (detail II) .
PROVIDED
#14B x 5/8 HEX
WASHER HEAD
TAPPING SCREWS
4 PROVIDED
SCREWS

Wall Or Counter Mounted Cheesemelters

Model GIRCM36C

1 . Clearance from combustible construction must be six
inches (6", 152mm) minimum at the rear and six inches
(6", 152mm) minimum at both sides .
The appliance shall be located with respect to building
construction and other equipment so as to permit access
to the appliance . Such access and clearance may be
necessary for service and cleaning .
2 . Counter models are furnished with 4" (102mm) legs .
Level the unit with a carpenter's level and make minor
adjustments with the threaded leg feet . Ensure that the
counter top can support the weight of the appliance
prior to installation and is comprised of non-combustible
material .
DETAIL I
ALL 60" RANGES
DETAIL II
ALL 60" RANGES
Page 13