PEERLESS SUT645P Instalación Y Ensamblaje página 7

For Flat Back Displays
Begin with the shortest length screw, hand thread through washer, tilt bracket and spacer, if required, into display
2-1
as shown below. If screw cannot make three full turns into the display and fi t snug into place, select a longer length
screw from the baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used depending on the type of display.
NOTE: If display manufacturer's requirements state that more than 0.68" of ventilation is required, spacers may be
used to add an additional 0.5" (spacer P) or 0.75" (spacer Q) of space between the wall and the display as shown
below.
Display
If you have any questions, please call Peerless customer care at 1-800-865-2112
For Bump-Out or Recessed Back Displays
Begin with the shortest length screw, hand thread through washer, tilt bracket and spacer as required into display
2-2
as shown below. If screw cannot make three full turns into the display and fi t snug into place, select a longer length
screw from the baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112
WASHER
SCREW
TILT BRACKET (B)
Display
SPACER
7 of 38
Display
SPACER
WASHER
SCREW
TILT BRACKET (B)
ISSUED: 09-10-09 SHEET #: 202-9366-7 04-05-11
WASHER
SCREW
TILT BRACKET (B)