Installing Tilt Brackets - PEERLESS SUT645P Instalación Y Ensamblaje

Installing Tilt Brackets

• Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening can
cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the display inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to display or product may fail.
If display has obstructions on the back, remove them to allow the tilt brackets to be attached. Fully extend tilt brack-
2
ets (B) and place tilt brackets on back of display. Align to holes, and center vertically on back of display as shown
below. Attach the tilt brackets to the back of the display using the appropriate combination of screws, washers, and
spacers as required shown in steps 2-1 or 2-2.
NOTE: Top and bottom holes must always be used.
Verify that tilt brackets are properly aligned and then tighten screws using phillips screwdriver.
MULTI-WASHER
NOTE: For fl at back displays proceed to step 2-1. For bump-out or recessed back displays skip to step 2-2.
CENTER
BRACKETS
VERTICALLY
ON BACK OF
DISPLAY
NOTE: "X" dimensions should be equal.
MEDIUM HOLE FOR M5 SCREWS
SMALL HOLE FOR M4 SCREWS
LARGE HOLE FOR M6 SCREWS
WARNING
B
Notes:
• The number of fasteners used will vary,
• Multi-washers and spacers may not be
• Use the corresponding hole in the multi-
6 of 38
X
NOTE: Cut outs indicate
bottom of tilt brackets (B)
X
depending upon the type of display.
used, depending upon the type of display.
washer that matches your screw size.
ISSUED: 09-10-09 SHEET #: 202-9366-7 04-05-11