Mounting And Removing Flat Panel Display - PEERLESS SUT645P Instalación Y Ensamblaje

Mounting and Removing Flat Panel Display

• Always use an assistant or mechanical lifting equipment to safely lift and position the fl at panel displays.
• Be careful not to pinch fi ngers when opening and closing mount from the wall.
Fully extend tilt brackets (B) and move tilt brackets
3
toward wall plate (A) as shown in fi gure 3.1. Hook
the tilt brackets onto both sets of fl anges on wall
plate as shown in detail 1. Be sure fl anges of tilt
bracket are fully seated into wall plate fl anges.
B
fi g. 3.1
CAUTION
• Tilt bracket fl anges of both tilt brackets must fully
engage wall plate fl anges as shown in detail 1 or
product damage may occur.
WARNING
B
TILT
BRACKET
FLANGES
WALL
PLATE
A
FLANGES
B
TILT
BRACKET
FLANGES
DETAIL 1
8 of 38
Tighten safety screws using allen wrench (T) to
lock down safety latches securing tilt brackets to
wall plate as shown in detail 2. Reverse step 3 to
remove display.
ISSUED: 09-10-09 SHEET #: 202-9366-7 04-05-11
WALL
PLATE
SAFETY
LATCH
SAFETY
SCREW
DETAIL 2