Tabla de contenido
Publicidad
38
IMPACT DRILL
THE NUMBERS IN THE FOLLOWING TEXT
CORRESPOND WITH THE PICTURES AT PAGE 2
CONTENTS:
1. Machine data
2. Safety instructions
3. Assembly
4. Use
5. Service & maintenance
1. MACHINE DATA
TECHNICAL SPECIFICATIONS
Voltage
Frequency
Power input
No load speed
Impact rate
Max. drill diameter (Wood)
Max. drill diameter (Concrete) | 13 mm
Max. drill diameter (Steel)
Weight
Lpa (sound pressure)
Lwa (sound power)
Vibration value
PRODUCT INFORMATION
Fig.A
1 Drill depth limiter
2 Chuck
3 Switch for normal and percussion drilling
4 Side handle
5 Left/right switch
6 On/off switch with speed control
7 Switch lock
PACKAGE CONTENTS
The package contains:
1 Impact drill
75 Accessories
1 Instruction manual
1 Warranty card
Check the machine, loose parts and accessories for
transport damage.
2. SAFETY INSTRUCTIONS
The following symbols are used throughout this manual:
Denotes risk of personal injury, loss of life or
damage to the tool in case of non-observance of
the instructions in this manual.
Ferm
Ferm
Denotes risk of electric shock.
In accordance with essential applicable safety
standards of European directives
Class II machine - Double insulation - You don't
need any earthed plug.
Variable speed control
Immediately unplug the plug from the mains
electricity in the case that the cord gets damaged
and during maintenance
Wear eye and ear protectors
Faulty and/or discarded electrical or electronic
apparatus have to be collected at the appropriate
recycling locations.
| 230 V
| 50 Hz
Carefully read this manual before using the machine.
| 500 W
Make sure that you know how the machine functions and
| 0-2500/min
how to operate it. Maintain the machine in accordance
| 0-40000/min
with the instructions to make sure it functions properly.
| 25 mm
Keep this manual and the enclosed documentation with
the machine.
| 10 mm
| 1.9 kg
ELECTRICAL SAFETY
| 90.0 dB(A)
| 103.0 dB(A)
Always check that the power supply corresponds to
| 10.8 m/s
2
the voltage on the rating plate.
Your machine is double insulated in accordance
with EN 50144; therefore no earthwire is required.
Replacing cables or plugs
Immediately throw away old cables or plugs when they
have been replaced by new ones. It is dangerous to insert
the plug of a loose cable in the wall outlet.
Using extension cables
Only use an approved extension cable suitable for the
power input of the machine. The minimum conductor
size is 1.5 mm
2
. When using a cable reel always unwind
the reel completely.
BEFORE OPERATING THE MACHINE:
•
Check the following:
•
Do the voltage of the machine correspond with the
mains voltage
•
Are the mains lead and the mains plug in a good
condition.
•
Do not use extension cables which are too long. Use
extension cables with a core diameter of 1.5 mm
minimal and only when the cable is rolled out
completely.
•
In case of a blockage, switch of the machine
immediately.
•
Always compare the maximum rotation speed of
accesoires with the maximum speed of the
percussion drill.
2
3
Publicidad
Tabla de contenido
