Cebora SYNSTAR 330 TC Manual De Instrucciones página 25

• Factory setup resetting.
This function allows return to the factory preset values.
Three resetting modes are possible:
- All.
- Resets only stored "job" working programs.
- Excludes the "jobs": Resets all but saves "Job" work-
ing programs.
Turn the knob 2 to select the function and confirm the
selection by holding down the knob.
To confirm the value simply hold down the knob 2.
To exit the function press the key
• Languages. Language selection.
Turn the knob 2 to select the function and confirm the
selection by holding down the knob.
To confirm the language simply hold down knob 2.
To exit the function press the key
• USB Port Function.
This function is activated only when a USB key is
plugged into the connector 6.
Turn the knob 2 to select the function and confirm the
selection by holding down the knob.
To confirm the selection simply hold down knob 2.
To exit the function press the key
• Use PIN
You can block the use of the PROCESSES, MATERI-
ALS and PARAMETERS using a lock code.
.
G
In this section you can save, modify, restore, copy or
cancel the working programs.
Saving of a "JOB" program".
After finding the ideal welding condition to be saved,
press the key
ble job number; to confirm the selection press the key
SAVE .
The saved string shows the process, the type and the
diameter of the wire.
Before saving the working program, you may select the
number under which you want to save it by simply turning
the knob 2 onto the selected number.
The job screen shows the job knob SAVE and two ad-
ditional buttons COPY and
button you can copy any save any job program and save
it again onto another number while with the "del" button
you can delete any saved job program.
If you press the button JOB you open the screen with
all the saved job programs while by pressing the button
RCL and the button OK you can recall any program
among the saved ones, to modify it.
The button with the selected program number
displayed on the main screen shot ; if you turn the knob
2 you may recall one after the other all the saved job pro-
grams in order to modify them.
.
H
I
L
Job Menu.
JOB
, the screen displays the first availa-
Accessory presence - Cooling unit.
(optional).
Accessory presence - welding mask.
Bluetooth controlled (optional).
Accessory presence - Push Pull torch
(optional).
DEL if you press the first
JOB
1
is
25