Important - Astralpool VRAC Manual De Instalación Y Mantenimiento

ADVICE DURING INSTALLATION AND ASSEMBLY OPERATIONS.
During the connection operations of the electrical wiring to the valve modules, great attention
must be given to polarity, and it must be verified that pieces of wiring are not left inside after
closing.
The connections should be made by following the electrical diagram included with the valve
module.
It should be verified that the electrical wiring connections to the valves electronic card are
firmly made.
The seal on the module's box should be checked for correct positioning to prevent the entry of
water, it should also be checked that the compression gland is also correctly located
Particular attention should be paid, so that, under no circumstances, is it possible for water to
enter the electronic module. In the case where the intended use is not that for which the valve
was designed, adaptation and supplementary technical regulations may be necessary.
ADVICE FOR WHEN PUTTING INTO SERVICE.
Before putting the automatic valve into service, it is necessary to verify the calibration of the
electrical protection devices in the operations cabinet and that they are correctly positioned
and fixed in place.
NOTE: It is recommended that the bathing facilities are not used while the filtration equipment
is in operation.
ADVICE DURING INSTALLATION AND MAINTENANCE WORK.
National installation regulations must be taken into account when assembling and installing
the automatic valve.
Extra care must be taken so that it is not possible, under any circumstances, for water to enter
the automatic valve electronic circuit.
All contact, including accidental, must be avoided at all times with the moving parts in the
automatic valve during operation and/or before complete shutdown.
Before carrying out any maintenance or any other electrical or electronic work, it must be
ensured that switch-on devices are locked.
It is recommended that the following steps be taken before performing any maintenance on
the automatic valve.
1.- Remove electrical power to the valve.
2.- Lock the switch-on devices.
3.- Verify that there is no electrical power being applied to the circuits, including auxiliary
and supplementary services.
This list must be considered indicative and not binding with respect to safety, there may be
other specific safety standards in particular regulations.
IMPORTANT: due to the complexity of the situations covered, the instructions for installation,
use and maintenance contained in this manual, do not make any attempt to cover all possible
service and maintenance cases. If additional instructions are necessary or specific problems
arise, please do not hesitate in contacting the distributor or the valve manufacturer directly.
Our automatic valves may only be installed in swimming or other pools which fully comply with
the HD 384.7.702 standard. When any doubt exists a specialist should be consulted.
Please check the packing contents.
4
ENGLISH