Manual Program; Remote Control Maintenance - Astralpool VRAC Manual De Instalación Y Mantenimiento

Once communication confirmation is received, the following function can be selected by
pressing the arrow, which will then provide access to the other functions:
WASH and BACK-WASH: proceed in a similar way.

3.4 MANUAL PROGRAM

Switch on the programmer by pressing the "ON" key with the control pointing at the valve and
the current function will be displayed on-screen.
Press the "MANUAL" key
If, for example, the following screen is displayed:
FILTRATION
MOTOR: ON
If the PUMP key is pressed, the following screen is displayed:
FILTRATION
MOTOR: OFF
In this way the PUMP can be programmed OFF.
Then press the "=" key with the control pointing at the valve module until it is confirmed that
the signal is received.
It is not necessary to stop the pump in order to change position, the program will perform this
automatically.
The next step is to select the function to be accessed.
By using the VALVE key, the valve will rotate, passing through the FILTRATION, SKIMMER
FILTRATION, EMPTY, CLOSED, BACKWASH, RE-CIRCULATION and RINSE positions.
Press AUTO to return to the AUTOMATIC program with the control pointing at the valve
(TRANSMISSION COMPLETED will be displayed). The current function will then be dis-
played.
WAIT!
VALVE MOVING
WARNING: when the module motor is operating, there is no transmission and valve movement
must be allowed to finish and the filter pump to start up in order to execute any programming
command.

3.5 REMOTE CONTROL MAINTENANCE.

The remote control is a piece of electronic equipment and as such, should be handled with
great care, it should not be dropped or allowed to get wet.
It does not require any maintenance other than removing the batteries while the swimming
pool is not being used during the cold months. It should be stored in a dry, dust-free place.
13
ENGLISH