Reinstall Hybrid Filters - Best WCP3I Serie Manual De Instalación

15. INSTALL DECORATIVE FLUE
A :
LL INSTALLATIONS
Carefully slide in place decorative flue base (notches end first) in the groove
(shaded part in inset at right) behind the exterior wall of the top of the hood.
D :
UCTED INSTALLATIONS
Slide up the upper flue until it is aligned with its mounting bracket. The bracket must be
inside the flue. Secure the upper flue to its bracket using 2 no. 8 x 3/8" screws (included).
See illustration beside.
NOTE: Duct not shown in illustration to ease understanding.
N - :
ON DUCTED INSTALLATION
Slide the upper flue up to the ceiling. The plenum must be inside the flue. Secure the upper
flue to the plenum sides using 2 no. 8 x 3/8" screws (included) per side for stainless steel
model or 2 no. 8 x 1/2" black screws (included) per side for black stainless model.
NOTE: Ceiling not shown in illustration to ease understanding.
A :
LL INSTALLATIONS
Remove protective plastic film covering the upper flue.

16. REINSTALL HYBRID FILTERS

Rest rear filters edge on filter springs in the range hood. Using finger cup, tilt up the filters into position.
Make sure both tabs (A) are securely engaged in range hood front edge slots after installation.
HO0272
U
11
U
PPER FLUE MOUNTING BRACKET
F
RONT VIEW
PPER
FLUE
HO0140
HA0136
HD1100
A