Prepare The Installation; Select Installation Type - Best WCP3I Serie Manual De Instalación

1. PREPARE THE INSTALLATION

When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves.
NOTE: Before proceeding to the installation, check the contents of the box. If items are missing or damaged, contact the manufacturer.
Make sure that the following items are included:
- Hood
- Accessories • Decorative flue assembly (lower and upper flues)
• Hood mounting bracket
• Upper flue mounting bracket
• 2 hybrid filters
• 6" round adapter/damper (for vertical discharge), in a bag
• 3¼" x 10" adapter/damper (for horizontal or vertical discharge)
• Bag of parts including: 5 no. 8 x 1½" countersunk screws, 8 no. 8 x 3/4" screws, 6 no. 8 x 3/8" screws,
Parts sold separately:
- Duct, elbows, wall or roof caps.
- Optional flue extension for 10-ft. ceilings model AEWCP3SB.
- Non-duct kit model HRKBSS, mandatory for non-ducted installation.
NOTE: The maximum ceiling height must not exceed 9 ft. when using a non-duct kit.
Before installation, remove and discard the shipping bracket (in grey) and its retaining
screws. See illustration on the right.

2. SELECT INSTALLATION TYPE

NOTE: During the installation, protect countertop and/or cooktop.
2.1 N -D I
ON UCTED NSTALLATION
The non-duct kit model HRKBSS is required for a non-ducted installation.
2.2 D I
UCTED NSTALLATION
Plan where and how the ductwork will be installed.
Install proper-sized ductwork, elbows and roof or wall cap depending on the type
of installation. For vertical discharge, use 6" round or 3¼" x 10" ductwork and for
horizontal discharge use 3¼" x 10" ductwork only. Use metal foil duct tape to seal duct
joints.
2.3 A I
LL NSTALLATIONS
The minimum hood distance above cooktop is 24" (30" over a gas range). A
maximum of 30" above cooktop is recommended for best capture of cooking
impurities.
Distances over 30" are at the installer and users discretion providing that ceiling
height and decorative flue length allow it.
C
EILING HEIGHT
8 .
FT
9 .
FT
10 .*
FT
* 10-ft. ceilings require flue extension model AEWCP3SB (sold separately).
6 drywall anchors, 3 washers, 2 no. 8 x 1/2" , 2 neoprene pieces. If need be,
discard extra hardware.
M
INIMUM HOOD DISTANCE ABOVE
ELECTRIC RANGE COOKTOP
24 .
IN
28½ .
IN
28½ .
IN
WARNING
!
HD0937
M
INIMUM HOOD DISTANCE
ABOVE GAS RANGE COOKTOP
30 .
IN
30 .
IN
30 .
IN
3
S
CREW LOCATIONS
R
OOF CAP
D
ECORATIVE
F
LUE
H
OOD
R
EFER TO CHART
FOR DISTANCE ABOVE
COOKING SURFACE
HH0246A
3¼" 10"
X DUCT
6 "
OR ROUND DUCT
W
ALL
C
AP
3¼" 10"
X DUCT