Emptying The Pulp Container And The Filter - Silvercrest SFE 450 C1 Instrucciones De Uso

2) Hold the pusher 1 in one hand and feed the fruit or vegetable pieces with the
other hand into the feed tube 2 . Always use the pusher 1 to carefully press
the fruit/vegetable pieces into the feed tube 2 . While the fruit/vegetables
are being processed, insert further pieces into the feed tube .
Do not switch the appliance off .
NOTE
► Add carrots one after the other into the feed tube 2: the top of the carrot
must be at the bottom and the pointed end at the top .
NOTE
► To avoid fruit or vegetables becoming blocked in the feed tube 2, only
fill it when the appliance is switched on . If fruit or vegetable pieces get
stuck in the feed tube 2 and cannot be promptly freed with the pusher 1,
proceed as follows to avoid damage to the appliance:
3) Always switch the off appliance immediately after all of the fruit/vegetables
have been processed .
CAUTION! PROPERTY DAMAGE!
► To avoid blockage of the juice outlet 6 and/or damage to the appliance,
clean the juice outlet 6 and the juice tank 5 regularly and after every
use .

Emptying the pulp container and the filter

■ You can extract juices continuously until the container for fruit and vegetable
pulp q is completely full .
WARNING! RISK OF INJURY!
► Remove the plug 8 from the power outlet when emptying the filter w .
This prevents unintentional starting of the appliance .
If the extracted juice suddenly starts getting thicker, or if you hear that the motor is
running more slowly, the filter w needs to be emptied . When you have removed
the fruit pulp, reassemble the appliance .
SFE 450 C1
–
Switch the off appliance immediately and pull the power plug 8
from the wall socket .
–
Undo the clamps 4 and remove the lid 3 .
–
Remove the fruit or vegetable pieces causing the blockage .
–
Reassemble the appliance and continue with juice extraction .
GB │ MT │ 65 ■