Reset Function/Safety Cut-Out; Assembling And Operating The Appliance - Silvercrest SSJBK 300 B2 Instrucciones De Uso

Reset function/Safety cut-out

This appliance is equipped with a safety cut-out to protect the motor.
If fruit pieces get stuck and the appliance turns itself off, the safety cut-out has
tripped. The appliance switches itself off before the motor can be damaged due
to overheating.
The appliance cannot be switched back on until you reset the safety cut-out.
Proceed as follows to be able to use the appliance again:

Assembling and operating the appliance

■ Before using the appliance for the first time, clean all component parts
thoroughly as described in the section "Cleaning and care".
■ Install the appliance in accordance with the safety instructions.
►
SSJBK 300 B2
–
Set the On/Off switch
power cable out of the socket. Allow the appliance to cool down
for 10–15 minutes.
–
Turn the housing lid
the marking on the sieve tray holder
–
Remove the housing lid
–
Remove the fruit or vegetable pieces causing the blockage.
–
Carefully remove the sieve tray
–
Insert the plug of the power cable
–
Press the RESET button
ance base
–
Pull the plug of the power cable
appliance base
–
Reassemble the appliance as described in the following section and
continue with juice extraction.
WARNING! RISK OF INJURY!
Ensure that the plug on the power cable
assembling the appliance.
to the "O" position and pull the plug of the
anticlockwise until the
.
and turn the appliance base
into a mains socket.
that is on the underside of the appli-
.
out of the socket and turn the
over.
is not in the socket before
marking points towards
.
GB │ IE │
over.
11 ■