Craftsman professional 171.264630 Manual Del Propietário página 15

MOUNTING THE ROUTER TABLE TO A
WORK SURFACE OR WORKBENCH
Ii _, I=LWARNINGI The router table must always be
FIRMLY and SECURELY mounted to a work surface
before use. Failure to do so could cause the router
table to tip over or slide, resulting in property
damage and/or serious personal injury.
TOOLS REQUIRED (not included)
• Phillips screwdriver
• Small sized adjustable wrench
• Electric or hand drill with drill bits (depending on
mounting method used)
• Fasteners (not included):
• Four #14, #16, or #18 x 2" pan head wood
screws (for solid wood work surfaces or
workbenches), or
• Four 5/16" pan head machine screws, washers,
and hex nuts, or
• Clamps.
METHOD 1 (FIGURE 4)
1. Set the router table on a workbench or other
stable and sturdy surface, with the FRONT
(switch side) of the router table facing
toward you.
2. While holding the router table in the desired
position, mark the location of the four mounting
holes (one in each corner).
3. Remove the router table from the workbench and
set it aside.
4. Drill a 1/8" pilot hole (for wood screws) or an
appropriately sized hole (for machine screws) at
the marked locations.
5. Place the router table on the workbench and
align the mounting holes in the router table legs
with the holes drilled in the work bench.
6.
Secure the router table in place using wood
screws (not provided) or machine screws,
washers, and nuts (not provided). If using
wood screws, applying a little soap to the
screw threads will make it easier to thread
the screws into the pilot holes.
Figure 4
Figure 5
METHOD 2 (FIGURE 5)
1, Set the router table on a workbench or other
stable and sturdy surface, with the FRONT
(switch side) of the router table facing
toward you.
2.
Secure the router table legs to the workbench
with clamps, making sure to tighten them
SECURELY.
IMPORTANT: Be sure the placement of the
clamps will not interfere with operation of the
router table.
7. TIGHTEN all screws SECURELY.
15