Craftsman professional 171.264630 Manual Del Propietário página 20

ASSEMBLING THE FENCE
TOOLS REQUIRED (not included)
• Phillips screwdriver
• Small sized adjustable wrench
FENCE SUPPORT BRACKETS (FIGURE 12)
1.
2*
,
Insert a #10-32 KEPS (31) nut into each of the
hex-shaped openings in the fence guides, with
the toothed washer facing towards the fence
guide as shown in Detail 12A.
NOTE: The KEPS nuts should "bottom-out" in
the hex-shaped openings on the fence guides.
It may be helpful to place the fence guides on
a flat surface and lightly tap the nuts in with
a small hammer.
Attach the fence guides to the fence support
brackets using two #10-32 x 1/2" long truss head
machine screws (44), as shown in Figure 12.
DO NOT tighten the screws at this time.
The orientation of the fence guide in relation
to the fence support bracket must be as
shown.
Loosely assemble two 1/4-20 nuts (48) and
1/4-20 x 5/8" long truss head machine screws (46)
to each fence support bracket, as shown in Figure
12. It is not necessary to tighten the fasteners at
this time.
Figure 12 -- 1/4-20x 5/8"
(__ L- --(-_/_ machine screws
/ ,\ J#,o32xl,2
Fence / .
_ _
Fence
support v// '\ '_/ guide
bracket , _/,
#10-32 KEPS nuts_
Detail 12A Fence
guide
_ #10-32KEPS _ / nuts
r\
2O