Craftsman professional 171.264630 Manual Del Propietário página 32

INSTALLING A WET/DRY VAC
INSTALLATION OF A WET/DRY MAC
TO THE DUST COLLECTOR
The guard/dust collector assembly has a port for
connecting a wet/dry vac hose with a 2-1/2" nozzle.
To attach, simply push the nozzle into the port while
holding the fence assembly in place.
For increased convenience, the vacuum cord can
be plugged into the second outlet on the switch box,
in the same manner as the router cord. Refer to the
instructions and safety warnings on page 27 for
SAFE and proper installation.
[_CAUTION} Operating the router table without
a wet/dry vac can result in an excessive build-up of
sawdust and wood chips under the fence assembly
and overhead guard, reducing the performance of
the router table and fence assembly.
RECOMMENDATION: To maximize performance,
regardless of whether a wet/dry vac is being used,
remove the sawdust and wood chips from under the
fence assembly and overhead guard as needed.
RECOMMENDATION: It is always a good practice to
keep the work area clean. As necessary, remove any
accumulated sawdust and wood chips from the top
of the router table, as well as from the surrounding
work area and floor.
MAKE SURE THAT THE ROUTER IS TURNED OFF
AND/OR UNPLUGGED WHEN DOING THIS!
32