Craftsman professional 171.264630 Manual Del Propietário página 17

ASSEMBLING THE ROUTER TABLE FLOOR STAND
(Model 9-26464)
TOOLS REQUIRED (not included)
• Phillips screwdriver
• Small sized adjustable wrench
ATTACHING THE LEVELING FEET TO THE
LEGS
(FIGURE 7)
1. Attach a leveling bracket to the inside of each
of the four legs using three #10-32 KEPS (31)
nuts and three #10-32 x 1/2" long truss head
machine screws (44).
NOTE: To simplify assembly and leveling of the
stand, set all four leveling brackets to their fully
retracted position and tighten the fasteners. You
may need to adjust the leveling brackets to your
floor surface later.
2. Slide a rubber leveling foot onto the end of each
leveling bracket.
Figure 7
Leveling bracket Levelir
#10-32 x 1/2 _ _,_
machine
screws
foot
/
D D
J
ATTACHING THE LEGS TO THE SHELVES
(FIGURE 8)
NOTE: Both shelves for the floor stand are identical,
as are all four legs.
1,
Place a shelf upside down (flat side down,
mounting flanges facing up) on the floor or
other stable work surface. This will be the
top shelf of the router table floor stand.
2.
Using four #10-32 KEPS nuts (31) and four
#10-32 x 1/2" Ig. truss head machine screws
(44), attach a leg to each corner, as shown in
Figure 8.
SECURELY TIGHTEN all fasteners.
3.
Attach the lower shelf, with the mounting flange
facing the leveling feet, to the legs using four
#10-32 KEPS nt_ts (31) and four #10-32 x 1/2"
Ig. truss head machine screws (44) on each leg.
SECURELY TIGHTEN all fasteners.
NOTE: It may be easier to align and attach the
lower shelf if you turn the stand on its side.
# 10-32
KEPS nuts
#10-32 x 1/2"
machine
screws
17