Craftsman professional 171.264630 Manual Del Propietário página 18

ATFACHING THE ROUTER TABLE TO THE
FLOOR STAND (FIGURE 9)
1, Turn the floor stand upright and set it on its feet.
2. Place the router table on the floor stand and
align the holes in the router table legs with the
square holes in the corners of the top shelf of
the floor stand.
3. From underneath, slide a 1/4-20 x 1-3/4" carriage
bolt (42) up through the hole in the top floor stand
shelf and router table leg, and secure with a
9/32" ID x 5/8" OD x 1/16" washer (40) and a
large clamping knob. Repeat for the other
three corners.
LEVELING THE FLOOR STAND
1. Place the router table and floor stand in the
desired working location. When selecting a
location, be sure to keep in mind sufficient
working space, lighting, and proximity to a
suitable electrical outlet.
2. Adjust the leveling brackets as needed to make
sure that the router table surface is level and that
all four leveling feet are in solid contact with the
floor. An assistant may be helpful in keeping the
table level and stable until all four leveling legs
are securely tightened.
Figure 9
Clampin_
knob and I III I _ 1 __ I I
i I
L
1
18