Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING TABLE TOP INSERTS IN THE ADAPTER PLATE
TABLE TOP INSERTS
(FIGURE
27)
This router table includes three table top inserts with
the following hole sizes:
• 1" in diameter for use with bits with diameters up
to 7/8"
• 2" in diameter, for use with bits with diameters up
to 1-7/8"
• 2-3/4" in diameter, for use with bits with diameters
up to 2-5/8"
The adapter plate has a 3-5/8" hole for use with bits
with diameters of up to 3-1/2". No insert is used for
bits with diameters over 2-5/8".
I A
I
I ALWARNINGI
Do not use the router table with
bits over 3-1/2" in diameter
A 3-1/2" diameter
bit is the largest bit that can be used with the
router table!
MAKE SURE THE ROUTER IS TURNED OFF
AND/OR UNPLUGGED BEFORE PROCEEDING!
TO INSTALL TABLE TOP INSERTS (FIGURE 28):
1.
Select the table top insert that best
accommodates the router bit to be used.
2.
Press the insert into the large hole in the router
adapter plate. If the fence is in the way, loosen
the clamping knobs on the fence support
brackets and slide the fence back out of
the way.
3.
Press down evenly over the tabs until the insert
locks into place.
4,
To remove, first remove the router bit from the
router. Then insert a finger into the hole in the
table top insert and pull up gently until the tabs
disengage. When not in use, store table top
inserts in a convenient place.
Figure 27
O
2-3/4" hole
(_
2" hole
1" hole
3-5/8" hole in
routeradapter
plate
Figure 28
• I
--
33
Publicidad
Tabla de contenido
