Troy-Bilt 01905 Manual Del Propietário página 11

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Section 4: Operation
5.
Make sure garden hose is connected to water inlet.
Check that high pressure hose is connected to spray
gun and pump and start engine.
6.
Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward,using
long, even,overlapping strokes.
7.
Allow detergent to soak in between 3-5 minutes
before washing and rinsing. Reapply as needed to
prevent surface from drying. DO NOT allow detergent
to dry on (prevents streaking).
IMPORTANT:You
must flush the chemical injection
system after each useby placing the filter into a bucket of
clean water, then run the pressure washer in low pressure
for I-2 minutes.
Pressure Washer
Rinsing
After you have applied detergent, scour the surface
and rinse it clean as follows:
I.
2.
.
Apply safety latch to spray gun.
Remove black chemical spray tip from nozzle
extension.
Select and installdesired high pressure spray tip
following the instructions "How to Use SprayTips".
WARNING
Keep spray nozzle between 8 to 24 inchesaway from cleaning
surface.
Operate this unit on a stable surface.
Be extremely careful if you must use the pressure washer from
a ladder,scaffolding or any other relatively unstable location.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury if gun kicks back.
4.
Increase or decrease spray pressure by turning
pressure control knob counterclockwise or clockwise
respectively (Figure 9). Use lower pressure to wash
items such a as a car or boat. Use higher pressure to
strip paint and degrease driveways.
Pressure
---
Control
Knob
5.
Apply a high pressure spray to a small area and check
surface for damage.If no damageis found, assume it is
okay to continue rinsing.
6.
Start at the top of the area to be rinsed, working
down with same overlapping strokes as you used for
cleaning.
Automatic
Cool
Down
System
(Thermal
Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures
above 125°F.Thesystem engagesto cool the pump by
discharging
the warm water onto the ground.
t

Publicidad

Tabla de contenido
loading

Tabla de contenido