Troy-Bilt 01905 Manual Del Propietário página 6

ASSEMBLY
IMPORTANT: Read entire owner's manual before you
attempt to assembleor operate your new pressure washer.
Remove Pressure Washer From
Carton
• Remove the parts bag packed with pressure washer.
• Slice two corners at the end of carton from top to
bottom so the panel can be folded down fiat, then
remove all packing material.
• Roll pressure washer out of carton.
Carton Contents
Items in the carton include:
• Main Unit
Safety Goggles
Handle
High Pressure Hose
Spray Gun
Nozzle Extension with Quick Connect Fitting
Oil Bottles (2)
Parts Bag (which includesthe following):
Owner's Manual
Engine Manual
Owner's Registration Card
Bagcontaining5 mult_olored Quick Connect Spray
Tips
Maintenance Kit
Handle Fastening Hardware Kit (which includes):
Carriage Bolts (2)
Plastic Knobs (2)
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged,call the
pressure washer helpline at 1-888-611-6708.
To prepare your pressure washer for operation, you
will need to perform these tasks:
I. Fill out and send in registration card.
2. Attach handle to main unit.
3. Remove shipping cap and install dipstick in pump.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
6. Connect high pressure hose to spray gun and pump.
7. Connect water supply to pump.
8. Attach nozzle extension to spray gun.
9. Select/attachquick connect spray tip to nozzle extension.
Attach Handle
I. Place handleassembly onto handle supports connected
to main unit. Make sure holes in handle align with holes
on handle supports (Figure I).
Align Holes _,_
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Insert carriage bolts through holes from outside of unit
and attach plastic knob from insideof unit (Figure 2).
Tighten by hand.
3. Insert multi-colored nozzles in spacesprovided in
handle.