Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Section 3: Assembly
Connect
Hose
and Water
Supply
to
Pump
IMPORTANT:
To avoid pump damage,you must assemble
the nozzleextension to the spray gun and attach all hoses
before you start the engine.
I.
Uncoil high pressure hose and attach quick connect
end of hose to baseof spray gun (Figure 4). Pull down
on collar of quick connect, slide onto spray gun and let
go of collar.Tug on hose to be sure of tight connection.
NOTE: Remove and discard alt pump shipping capsbefore
attaching hoses.
2.
Similarly,attach other end of high pressure hose to
high pressure outlet on pump. Pull down on collar of
quick connect, slide onto pump and let go of collar. Pull
on hose to be sure of tight connection.
3.
Before you connect your garden hose to water inlet,
inspectinlet screen (Figure 5). Clean screen if it
contains debris, replace if damaged.DO NOT RUN
PRESSUREWASHER IF SCREEN IS DAMAGED.
Inspectinlet
screen. DO NOT
use if damaged;
clean if dirty.
4.
Run water through garden hose for 30 seconds to
clean out any debris.Turnoff water.
INPORTANT:
DO NOT siphon standing water for the
water supply.Use ONLY cold water (less than IO0°F).
5.
Connect garden hose (not to exceed 50 feet in length)
to water inlet.Tightenby hand (Figure 5).
CAUTION
• Damage to equipment
resulting from failure to follow this
instruction will void warranty.
6.
Turn ON water and squeeze trigger on spray gun to
purge pump system of air and impurities.
WARNING
Always wear eye protection when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate eye protection.
Checklist
Before
Starting
Engine
Review the unit'sassemblyto confirm you haveperformed
atl of the following:
I.
Make sure handle is in place and secure.
2.
Make sure shipping cap was removed and oil distick
was installedin pump.
3.
Check that oil has been added to the proper level in
engine crankcase.
4.
Add proper fuel to fuel tank.
5.
Check for properly attached hose connections.
6.
Check to make sure that there are no kinks, cuts, or
damageto high pressure hose.
7.
Provide a proper water supply at an adequate flow.
8.
Be sure to read "Safety Rules" and "HowTo Use
PressureWasher" before using the pressure washer.
Publicidad
Tabla de contenido
