Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Section 4: Operation
How tO Use SprayTips
The quick-connect on the nozzle extension allows you to
switch between five different spray tips.The spray tips vary
the spray pattern as shown below (Figure 8).
CAUTION
NEVER exchange spraytips without lockingthe safetylatch
on the trigger.
Follow these instructions to change spray tips:
I.
Engage safety latch on spray gun.
2.
Putl back collar on quick-connect and putl current
spray tip off. Store spray tips in space provided on
handles storage panel.
3.
Select desired spray tip:
For gentle rinse, select white 40° or green 25°
spray tip.
To scour surface, select yellow 15° or red 0° spray
tip.
To apply chemical, select black spray tip.
3.
Putl back on collar, insert new spray tip and release
collar.Tug on spray tip to make sure it is securely in
place.
4.
For most effective cleaning, keep spray tip from 8 to
24 inchesaway from cleaning surface. If you get spray
tip too close, you may damage cleaning surface. DO
NOT get closer than 6 incheswhen cleaning tires.
Cleaning
and Applying
Chemical
IMPORTANT:
Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
CAUTION
Startingthe engine without all the hoses connectedand
without the water turned ON will damage the pump.
Damage to equipment resulting from failure to follow this
instructionwill void warranty.
apply detergent
follow these steps:
Review spray tip use.
Prepare detergent
solution as required by
manufacturer.
Placesmall filter end of detergent siphoning tube into
detergent container.
CAUTION
• When insertingthe filter into a detergent solution bottle,
route the tube so as to keep it from inadvertentlycontacting
the hot muffler.
4.
Make sure black spray tip is installed.
NOTE:
Detergent
cannot be applied with the high
pressure spray tips (White,
Green,Yellow, or Red).
Low Pressure
Black
High Pressure
White
Green
Yellow
Red
40°
25°
15 °
0°
m
Publicidad
Tabla de contenido
