Elite Arion Mag Instrucciones Para El Uso página 12

EN
Your ARION MAG roller should arrive fully assembled,
checked and ready for use.
Before starting to use your ARION MAG it is
necessary to adjust the centre distance of the rollers
to make them compatible with your bicycle's
wheelbase.
This adjustment must be carried out as follows:
Measure the distance between the centres of the
wheels of the bicycle to be used on the ARION MAG
(Fig.2). We will call this dimension "X".
The distance from the intermediate point between
the two rear rollers to the middle of the ARION MAG
front roller, which we will call "Y" (Fig.3), must match or
be as near as possible to dimension "X" . The axle of the
ARION MAG front roller must be positioned in the hole
12
X
2
of the ARION MAG frame whose measurement given on
the graduated scale is closest to dimension "X" (Fig.4).
3) To change Y it is necessary to shift the front roller E.
Fold the ARION MAG until the drive belt
slackens.
5) Loosen the drive belt
respective front and rear guides.
6) Unfold the ARION MAG back into the open position.
7) Remove the rectangular covers
longitudinal members (with aid of a screwdriver if
necessary), and the screws and washers from the
front roller on both sides, using the Allen key
supplied (Fig. 5).
8) Pull the roller out from its original position.
9) Position the roller in the appropriate seat in the
holes in the frame, so that X matches Y.
3
4
, making it come off the
from both front