Publicidad
Idiomas disponibles
Idiomas disponibles
Ingeteam
2.
Install the RS-485 communications cards in the rest of the charging stations that make up the
communication ring. They must be inserted into connectors J15 and J17.
3.
Connect the wiring that joins the communications card to the communications card of the following
charging station (see the dark grey cabling in the following figure).
Connect the USB modem to the communications card of the first charging station to obtain the GPRS/3G
connection.
The jumper of the communications card of the first charging station must remain in place.
Modem
16
Pin
Signal
1
RS-485 B (+)
2
RS-485 A (–)
6
GND
ABA2017IQM01_A - Installation and Operation Manual
INGEREV GARAGE Basic
Communications
card jumper
Publicidad
Capítulos
